Electrical

1.       The DC generator works on the principle of?
A] Fleming’s left hand rule
B] Fleming’s right hand rule
C] Lenz law
D] none of the above                                     Ans: b

2.       A 3 phase 4 wire system is commonly used for ?
A] primary distribution
B] secondary distribution
C] primary transmission
D] secondary transmission                           Ans:b

3.       A current  is said to be alternating when it changes in?
A] magnitude only
B] direction only
C] both magnitude and direction
D] none                                                                                Ans:c

4.       The slip of an induction motor normally does not depend on
A] rotor speed
B] synchronous speed
C] shaft torque
D] core loss component                                                Ans:d

5.       The frequency of voltage at the secondary of a transformer is
A] greater than that of primary
B] equal to that of primary
C] less than that of primary
D] none of the above                                     Ans:b

6.       Which of the following power plant is least reliable
A] wind
B] tidal
C] geothermal
D] solar                                                                 Ans:a

7.       DC motors are still preferred for use in
A] electric excavators, steel mills and carnes
B] lathe and machine tools
C] flour mills and jaw crushers
D] paper industry                                             Ans:a

8.       The highest transmission voltage in india is
A]750kv
B] 400kv
C] 220kv
D] 132kv                                                               Ans:b

9.       A negative sequence relay is commonly used to protect
        (A) an alternator  
(B) an transformer
 (C) a transmission line 
(D) a bus bar                                                      Ans:a

10.   For enhancing the power transmission in along EHV transmission line, the most
preferred method is to connect a
 (A)  Series inductive compensator in the line
 (B)  Shunt inductive compensator at the receiving end
 (C)  Series capacitive compensator in the line
(D)  Shunt capacitive compensator at the sending end    Ans:c    

11.  In a series RLC circuit that is operating above the resonant frequency, the current
lags the applied voltage
leads the applied voltage
is in phase with the applied voltage
is zero
Ans:a



12.  If the resistance in parallel with a parallel resonant circuit is reduced, the bandwidth
disappears
becomes sharper
increases
Decreases
Ans:d

13.  If the value of C in a series RLC circuit is decreased, the resonant frequency
is not affected
increases
is reduced to zero
Decreases
Ans:b


14.  If two currents are in the same direction at any instant of time in a given branch of a circuit, the net current at that instant
is zero
is the sum of the two currents
is the difference between the two currents
cannot be determined
Ans:b

15.  The Thevenin equivalent voltage is
equal to the source voltage
the same as the load voltage
the open circuit voltage
none of the above
Ans:c

16.  In a http://www.indiabix.com/_files/images/electrical-engineering/delta.gif-connected source feeding a Y-connected load,
each phase voltage equals the difference of the corresponding load voltages
each phase voltage equals the corresponding load voltage
each phase voltage is one-third the corresponding load voltage
each phase voltage is 60° out of phase with the corresponding load voltage
Ans:a


    17.   Polyphase generators produce simultaneous multiple sinusoidal voltages that are separated by
certain constant phase angles
certain constant frequencies
certain constant voltages
certain constant currents
Ans:a

18. A given power supply is capable of providing 6 A for 3.5 h. Its ampere-hour rating is
0.58 Ah
2.1 Ah
21 Ah
58 Ah
Ans:c

      19. A certain appliance uses 350 W. If it is allowed to run continuously for 24 days, how many  
kilowatt-hours of energy does it consume?
20.16 kWh
201.6 kWh
2.01 kWh
8.4 kWh
Ans:B

20. How many primary volts must be applied to a transformer with a turns ratio of 0.1 to obtain a secondary voltage of 9 V?
9 V
90 V
900 V
0.9 V
Ans:b

21. A 1.5 khttp://www.indiabix.com/_files/images/electrical-engineering/omega.gif resistor and a coil with a 2.2 khttp://www.indiabix.com/_files/images/electrical-engineering/omega.gif inductive reactance are in series across an 18 V ac source. The power factor is
564
0.564
6.76
55.7
Ans:b



22. To increase the current in a series RL circuit, the frequency
should be increased
should be decreased
should be constant
cannot be determined without values
Ans:b


23. A sine wave voltage is applied across a capacitor. When the frequency of the voltage is decreased, the current
increases
remains constant
decreases
Ceases
Ans:c

24. Two 1.5 V cells are connected series opposing across two 100 http://www.indiabix.com/_files/images/electrical-engineering/omega.gif resistors in series. Total current flow is
15 mA
5 mA
2 mA
0 A
Ans:d

25. A phasor represents
the magnitude and a quantity direction
the width of a quantity
the phase angle
the magnitude of a quantity

                      Ans:a

0 comments:

Post a Comment

You can replace this text by going to "Layout" and then "Page Elements" section. Edit " About "

powertroters

mus

blog

Hackgk.tk

Powered by Blogger.

Total Pageviews